- October 20th, 2010
- Write comment
This is the second part of my FTPES, vsftpd & CentOS article. In the first part I walked you thru how I built a certificate, sent the CSR off to my CA and finally, modified the vsftpd.conf file. In this part I’ll show you how to test the service via command-line so you can actually see the certificate and how to punch a hole thru your FW because the data part of your FTP session is now encrypted.
First, let’s talk about verifying the configuration. One of the obvious things you can do is open up a command prompt session and attempt to log into your ftp server. Once connected, does it accept an anonymous connection? Was that what you wanted? Also, was the plain jane ftp command allowing you to log in or did you get a 331 error, “Non-anonymous sessions must use encryption.” If you’ve configured it correctly it shouldn’t allow you to login at all. So how do you test it using encryption? By using openssl w/ s_client of course! Use…
openssl s_client -starttls ftp -connect yourserver.example.com:21
This will allow you to not only log into your server using encryption via command-line but also verify that you’ve got the proper certificate & certificate chain installed. I personally tried connecting w/ out the starttls option but wasn’t successful (instead I get a “SSL routines:SSL23_GET_SERVER_HELLO:unknown protocol” error message. I beleive this is because I’m using vsftpd in explicit mode not impicit mode.) The openssl s_client command can also be used for a number of other encrypted services for debugging certificates which is extremely helpful!
So you’ve verified that FTPES does work on the local LAN but doesn’t seem to work thru your FW. This is where passive ftp comes into play because your FTP traffic is now encrypted and your FW can’t do an inspection to determine which port is going to be used next and open it up for you ahead of time. Most FWs come with some sort of FTP inspect feature but we just killed it because that data is totally encrypted now and it’s unable to sniff the FTP traffic and sense which port needs to be opened. You won’t have to turn on passive FTP because it’s on by default with vsftpd. You should specify the port range and I also turned on pasv_address too:
pasv_enable=YES pasv_addr_resolve=YES pasv_address=yourserverhere.example.com pasv_min_port=63000 pasv_max_port=65535
Once done, this will force your vsftpd server to use a port range of 63000 to 65535 for data connections. Alot of the commands I used above can be found w/in the man page for vsftpd.conf (along with their default values!)
Now you just need to open up that same range on your FW device (NOTE: Each FW is going to be different!) On my Cisco Adaptive Security appliance (ASA) I’m defining an object-group first for the port range like such:
object-group service ftp_passive tcp description ftp passive range port-object range 63000 65535
Then I use that port range in my outside ACL for inbound traffic like such:
access-list outside_access_in extended permit tcp any host YOUR_PUBLIC_IP object-group ftp_passive . . .
Just be sure to use your public IP address for ‘YOUR_PUBLIC_IP’ in the above ACE. Now when it comes to ACL rules there’s tons of different ways to allow traffic so I won’t go into much more detail here other than how I punched a hole thru my FW to allow the encrypted vsftpd data channel traffic through.
That’s about it folks. Remember, if you’re having problems with your configuration, break it down into simple pieces and troubleshoot it that way versus trying to eat the entire problem at once!
Oh, almost forgot. Here’s a couple links that might be helpful!